Disassembling the Emiah electric office chair is straightforward if you follow these steps. Whether you need to disassemble it for repairs, part replacement, or transport, this guide will provide you with detailed instructions and precautions.
Preparation
Before starting the disassembly, it's recommended to prepare the following tools and materials:
- Screwdriver: For removing screws and fasteners.
- Wooden mallet and towel: For gently tapping the gas cylinder area.
- Gloves: To protect your hands from injury.
- Toolbox: To store disassembled parts and avoid losing them.
Step 1: Disconnect the Power Cord
First, ensure the chair is turned off and the power plug is disconnected. Open the cover located at the bottom rear of the chair, find the power cord connection, and disconnect it. Make sure the power cord is completely disconnected to avoid any accidents during the process.
- Turn off the chair and unplug the power cord.
- Open the cover at the bottom rear of the chair.
- Locate the power cord connection and gently disconnect it.
Step 2: Remove the Backrest
Next, locate the buckle that secures the backrest to the seat. Unfasten the buckle and lift the backrest up until it separates from the seat. Ensure that the process is smooth to avoid damaging any parts of the chair.
- Locate the buckle connecting the backrest to the seat.
- Press the buckle to unfasten the backrest.
- Gently lift the backrest upwards until it separates from the seat.
Step 3: Separate the Seat Cushion from the Base
Then, you need to separate the seat cushion from the base. Rock the seat cushion vigorously from side to side until it separates from the gas cylinder. This step may require some force, but be careful not to use excessive force to avoid damaging the seat cushion or the base.
- Hold the sides of the seat cushion with both hands.
- Rock the seat cushion vigorously from side to side to loosen it from the gas cylinder.
- Lift the seat cushion to separate it completely from the base.
Step 4: Separate the Base, Gas Cylinder, and Casters
Finally, you need to separate the base, gas cylinder, and casters. Rotate and pull out the casters to remove them. It is recommended to use a wooden mallet wrapped in a towel to gently tap the gas cylinder area to help separate the gas cylinder from the base. Handle this step carefully to avoid damaging any parts.
- Locate the connection points of the casters on the base.
- Rotate and pull out the casters to remove them.
- Wrap a wooden mallet in a towel and gently tap the gas cylinder and base connection area.
- Once the gas cylinder is loosened, separate it from the base.
Precautions
- Safety First: Ensure a safe operating environment during disassembly, keeping children and pets away.
- Handle with Care: Handle all parts gently to avoid damaging them.
- Parts Management: Store disassembled parts in a toolbox or designated bag to avoid losing them.
- Refer to the Manual: If unsure about any step, refer to the chair’s user manual or contact Emiah customer service for assistance.
Additional Tips
During the disassembly process, always operate carefully to avoid excessive force or using sharp tools, which might damage the chair or cause injury. Using a towel-wrapped wooden mallet can effectively protect the gas cylinder and base from scratches or dents.
By following these detailed steps and precautions, you can successfully disassemble the Emiah electric office chair. If you encounter any problems during the process, it is recommended to contact a professional technician or consult Emiah customer service for help.
We hope this guide helps you easily complete the disassembly of your Emiah electric office chair.
